5 Little Monsters: Burlap Bunny Banner

Burlap Bunny Banner

-This Post Contains Affliate Links-


I feel like this month I ended up with several craft challenge posts all ending up being scheduled within just a few days of each other and today I have another one. Today's challenge is the Create with Cricut Challenge where each month several bloggers share projects they made using their Cricut and a specific material. This month the material is burlap.



I decided that with Easter just about a week and a half away I would make a simple Easter project. I cut the banners with the rotary blade on my Cricut Maker, added a white vinyl bunny and then glued the top around a dowel. Then I added some lace trim and a ribbon. It was a super quick and easy project to make.


How To Make a Burlap Bunny Banner

You will need:



Open this design in Design Space.

I used 2 different shapes for each the banner and the bunny because I couldn't decide.

Use the rotary blade and a fabric mat to cut your burlap banners

Use the fine tip blade to but the bunnies from iron-on

Use the iron or EasyPress to press the bunny onto the burlap but be sure to leave some extra along the top edge so that you can fold it over the dowel

Cut the dowels so that they are just a bit longer the top edge of the banner.

Place the dowel close to the top edge and fold over and glue in place

Glue some lace along the top below the dowel. 

Tie a ribbon to the dowel for hanging




No comments :

Post a Comment